All about sharp cables

[guclusat]

GX10-GX10i-GX20:

only COM cable or USB to COM converter cable.is the same for data/unlock/flash. pinouts

KEY PAD
-------
1 2 3 4 5 6 7 8


9 10 11 12 13 14 15 16

pin 1 gnd (black)
pin 2 link to 10
pin 5 + (red) ext power +3..5V
pin 5 link to 12
pin 6 rx (white)
pin 7 tx (blue) open drain, connect 10k Resistor to pin5!
pin 9 link to 14



above PINOUTS are 100% working and TESTED by many of my FRIENDS....
even this pinouts are working with MAX232

 

[guclusat]

GX15-GX17-GX25:

only USB cable,not COM.for data and unlock use sipmle original USB cable.
FOR FLASH YOU NEED NEC 3G CABLE OR USB CABLE WITH CHARGING FUNCTION(see pic1).
caution:usually you can't use flash cable for unlock.


GX30-GX30i-TM100:

you can use USB and COM cable for data BUT ONLY COM CABLE WITH EXTERNAL POWER FOR FLASH AND UNLOCK(see pic2).


3G SEMC PHONES (802-902 etc) :

you can use USB and COM cable for data BUT ONLY COM CABLE OR USB TO COM CONVERTER CABLE FOR FLASH AND UNLOCK.(see the pic3 for VIDEO CONNECTOR pinouts).the most famoys in this case is the 4 in 1 CRUISER cable.
YOU CAN USE ALSO GX30 CABLE(connected to the charging connector ofcourse) but in this case speed will be too slow(115200).Also SPST work's better with that cable.

 

[guclusat]

searsch on sales section.


GX15/17/25 usb drivers for data and unlock: http://rapidshare.de/files/8176961/G...r_b14.exe.html


GX15/17/25 usb drivers for flash: RapidShare Webhosting + Webspace

 

[guclusat]

Drivers for flashing gx15 are included in the gx15 upgrading tool:
http://sharp.hacked.in/gx15/the%20gx...0installer.zip

You must install this software, and when is istalled connect your phone WITHOUT battery to your usb cable (with charging funcion) and then windows will auto install drivers from the folder of gx15 upgrading tool.

Once drivers are installed open the program and flash the phone

 

[guclusat]

I found this diagram on the forums for GX15, it should work alright shouldn't it? Please clarify the voltage required. Thanks Platijet.

I found this diagram on the forums for GX15, it should work alright shouldn't it? Please clarify the voltage required. Thanks Platijet.